Edwards Screw Bell Conversion & Who To Send It To

trombullion · Post by **trombullion** » Mon Apr 01, 2019 8:22 am

Hello TromboneChat hivemind,

I'm planning to have my T350 converted to a screw bell setup, mainly for the sake of peace of mind whilst traveling.

Are there any forum members who've had their Edwards converted? If so, who did your work?

Lastly, for those of you who have had it done, what cases work best? I've heard a few horror stories of converting, only to find that their horn couldn't fit in the case...

Thanks as always!

Post by **Bonearzt** » Mon Apr 01, 2019 9:02 am

Check with Justin Cooper at the University of North Texas, also BAC Horns, Gary Dafler and a few others that I can't remember names...

Eric

norbie2018 · Post by **norbie2018** » Mon Apr 01, 2019 10:24 am

MW Trombones do great work and advertise this kind of conversion.

Post by **BGuttman** » Mon Apr 01, 2019 10:46 am

Trombullion, where are you located? Your language indicates England, Australia, or New Zealand. All the suggestions are in the US.

trombullion · Post by **trombullion** » Mon Apr 01, 2019 10:50 am

Oops, I'll see if I can't figure out a way to change that. Thanks, Bruce. I'm located in the Southeast US.

Carter1016 · Post by **Carter1016** » Fri Apr 05, 2019 10:02 am

The owner I bought my horn from had the bell cut by Dan Oberloh. The horn was in an airline accident, so the previous owner had it repaired and cut by Dan Oberloh, I think he’s in Seattle.

Edwards Screw Bell Conversion & Who To Send It To

Edwards Screw Bell Conversion & Who To Send It To

Re: Edwards Screw Bell Conversion & Who To Send It To

Re: Edwards Screw Bell Conversion & Who To Send It To

Re: Edwards Screw Bell Conversion & Who To Send It To

Re: Edwards Screw Bell Conversion & Who To Send It To

Re: Edwards Screw Bell Conversion & Who To Send It To