Page 1 of 1
Adhesive Recommendations for Thayer Valve Bumpers.
Posted: Sat Jul 27, 2019 7:32 pm
by tromboninator4000
I have been suggested super glue but was wonder if there was a different adhesive that was not so messy and hard to clean up.
Re: Adhesive Recommendations for Thayer Valve Bumpers.
Posted: Sat Jul 27, 2019 7:50 pm
by BGuttman
A properly sized bumper probably doesn't need any adhesive.
If you just want to make the bumper less likely to fall out, rubber cement would work well. Let it dry for a day; maybe with a little heat from a hair dryer. Excess can be removed with a pencil eraser.
Re: Adhesive Recommendations for Thayer Valve Bumpers.
Posted: Sun Jul 28, 2019 4:08 pm
by tbonesullivan
Some versions of the thayer valve have less than a half circle for the bumper to rest in, so they pretty much need glue. Not sure why they made them that way.
Re: Adhesive Recommendations for Thayer Valve Bumpers.
Posted: Sun Jul 28, 2019 5:09 pm
by Bonearzt
tbonesullivan wrote: ↑Sun Jul 28, 2019 4:08 pm
Some versions of the thayer valve have less than a half circle for the bumper to rest in, so they pretty much need glue. Not sure why they made them that way.
A BIG peeve in my book!!! The recess SHOULD be "C" shaped with the ends curled in to contain the bumpers.
Too easy to cut corners, so to speak, and just mill them incorrectly!
If you must glue them in, use a rubber contact cement, the stupid glues will tend to make the rubber brittle after some time and also makes it hard to remove when the need replacing!
Eric