Where to buy trubore valve caps

[piezer]

I'm looking to try out heavy valve caps for my tru-bores, does anyone know where they are available? Googling hasn't come up with anything.

[hornbuilder]

Do Shires make them? If not, you will have to have them custom made (by Shires, or a machine shop)

[Matt K]

If you can't get them at Shires, I've had several valve covers made by Matt Frost at http://www.frostcustombrass.net/. True Bores might be a little too wide for his setup though. If you go that route, I'd check to see if he can make something of that diameter.

[GabrielRice]

TruBore valves have had two different valve caps since they were introduced. At some point (2008 or 9?) the original caps were replaced with heavier versions that everybody seemed to prefer. It took me a little time to adjust, but ultimately I liked them better.

If your TruBore valves are an older set, the current caps made by Shires will be heavier.

[piezer]

Do you happen to have any pictures of new vs old? I think mine are the old ones though because they say "The Shires Valve" on them as opposed to TruBore.

[GabrielRice]

Do you happen to have any pictures of new vs old? I think mine are the old ones though because they say "The Shires Valve" on them as opposed to TruBore.

I don't, sorry. You are probably correct that yours are older.

[Arvopart17]

Just put the cap from my 1 year old tru-bore on the scale and it was 47 grams. Just for reference against yours.